Pesto with Almonds and Cuban Oregano

 My indoor plants with automatic watering system were growing so well that I needed to repot them. I switched to a larger pot and also split some plants up. The Cuban oregano was two feet tall and required a lot of extra support. Unfortunately, in the process of repotting it, some leaves and stems broke. So I needed to find a recipe that used a lot of Cuban oregano.

I was inspired by a recipe I found online for Cuban oregano pesto: https://csaproducerecipes.wordpress.com/2015/10/13/funky-cuban-oregano/

I didn't have any pine nuts, so I used almonds. I added boiling water to about 3/4 cup almonds and let them soak until the peels could be rubbed off. I used about 1 1/2 cups of Cuban oregano leaves. Then I toasted a couple of garlic cloves and added those. I started with 1/2 cup of olive oil. I added at least another cup of herbs from the garden, including rosemary, chives, green onions, and basil. I mixed everything together in our old Osterizer blender. 

The blender has several speeds, but it wasn't working well. A vortex couldn't form in the middle because air got sucked in and then trapped in the thick sauce. I kept having to stop and "burp" it. There wasn't enough liquid and probably too many almonds. I added more oil and some water so that it could puree everything. I did a taste test, and it wasn't garlicky enough, so I added a couple raw cloves of garlic. I decided later that it wasn't salty enough. I don't have the nutritional yeast that some recipes call for, and I'm not vegan, so added parmesan when serving to make it saltier.

I had this flavorful creamy green sauce with homemade meatballs and fresh (from the grocery store) noodles with red sauce. I had a lot of sauce left over, so I froze it in small cubes.

Welding Table from Recycled Materials

 

I do welding in the garage or driveway because that's where the 240 volt outlet is, and I don't have a dedicated workshop for it. This means I need a table that can be moved out of the way of the cars. 

I made a welding table from three different trash-picked parts. I started with the metal frame from an outdoor table that was missing the glass top. To cover the top, I added a metal mesh panel that I collected a few years ago. That worked well, but had a sharp edge. I added rebar to the edge which made it safer and sturdier. 

After using the table that way for a couple of years, I decided that it needed some improvements. First, the table was too short to be comfortable. Second, it was difficult to move. Since I have to move the driveway into and out of the driveway every time I weld, it was annoying. I decided it needed wheels to fix that problem. Wheels are kind of expensive, so I put off adding them. Then I got a broken electric lawn mower that a neighbor was discarding. The wheels are perfect. I only needed two wheels, so that the table will roll when I lift one side, but won't move while I'm using it. 

The set of wheels with the axle between was too narrow to fit between the legs, so I attached each wheel separately to a leg. The new wheels added over 5 inches to the height, but then the other two legs were too short. I made leg extensions from the axle, cut in half with my angle grinder. Now the table is an even height. In the future, I will probably add feet to the leg extensions so that they won't sink into the ground when I park the table outside in the grass.